Ready Answers
A recurve blade curves in, so a flat stone can't reach the hollow. Use a round sharpening rod, diamond to set the edge and ceramic to finish it, and keep the same angle, about 20 to 25 degrees, the whole way. In the field, turn a flat stone on its edge to reach the curve, then strop it smooth.
Lay the blade nearly flat on the leather, raise the spine slightly, and pull the knife backward so the edge trails, never pushing the edge into the leather. Do the same number of light strokes on each side. Stropping polishes and refines an edge that's already sharp; it won't fix a dull one.
Lay the stone on a flat, non-slip surface, start on the coarse side, and hold one steady angle as you work the whole edge from heel to tip. Keep going until you can feel a small burr along the opposite side, switch sides, then repeat on the fine side and finish on a strop.